
SkiErg for HYROX: Technique, Pacing and Damper Settings
HYROX SkiErg technique decides how your whole race feels — not because station 1 is long, but because it's first. One thousand metres, straight off the opening run, on a machine most runners have barely touched. Ski it with your arms and you'll pay on the sled; ski it with your hips at a controlled pace and it becomes the cheapest station of your day. Here's the stroke, the damper, and the pacing that works.
The HYROX SkiErg is 1,000 m for every division, with the damper preset to 6 (you may change it). SkiErg technique in one line: reach tall, drive the handles down by hinging at the hips — arms are just ropes — finish past your hips, and hold a pace 5–10 seconds slower than your fresh best. Keep both feet on the base plate, and at 1,000 m raise an arm and wait for the judge before stepping off.
The SkiErg standard and rules
Every division — Open, Pro, Doubles and Relay — skis the same 1,000 m on a Concept2 SkiErg, immediately after the first 1 km run. The rules that actually matter:
- The damper is preset to 6, and in Singles you may adjust it as often as you like during the station.
- Both feet stay on the base plate. Heels may hang over the edge but must not touch the floor. A dynamic, jumping style where your feet briefly leave the plate is allowed.
- Finish properly: when the monitor reads 1,000 m, keep both feet on the plate, raise one arm, and leave only once the judge confirms. Leaving early means an incomplete station — a disqualification risk, not a small penalty.
HYROX SkiErg technique, step by step
1. Start tall and reach high
Feet about shoulder-width apart, knees soft. Reach up to full extension — hands above your head, body long. Height at the catch is free distance per stroke; short athletes who reach properly ski like taller ones.
2. Drive with the hinge, not the arms
Initiate the stroke by hinging at the hips and engaging your lats, letting your bodyweight fall onto the handles. Your arms should feel like ropes connecting you to the machine, not like the engine. If your biceps and shoulders are burning at 300 m, you're arm-skiing — and the sled pull is about to collect.
3. Finish past the hips
Pull through until your hands pass your hips, elbows finishing behind the body. A short finish costs distance on every stroke and forces a frantic rate to hold the same pace. Then recover smoothly: stand back up, arms rising overhead — the recovery is your micro-rest inside every stroke.
4. Breathe on the recovery
Exhale on the drive, inhale as you stand up. One breath per stroke, set from the very first pull. The rhythm you establish here tends to be the rhythm your whole race breathes at.
The damper setting, explained honestly
The damper controls how much air enters the flywheel — it is not a difficulty dial, and 10 is not "harder" in a way that makes you faster. What it changes is the feel of each stroke:
| Damper | Feel | Suits |
|---|---|---|
| 3–4 | Light, fast strokes; needs a higher rate | Lighter athletes who ski with cadence |
| 5–6 | The balanced middle; the race preset is 6 | Most Open athletes — sustainable hinge power |
| 7 | Heavy pull per stroke, lower rate | Strong athletes who can produce force without burning out |
| 8–10 | Grinding, arm-dominant strokes | Almost nobody over a full 1,000 m mid-race |
Higher settings recruit more arm and shoulder — exactly the muscles the sled pull and farmers carry need intact later. Test 5, 6 and 7 in training over a few weeks and pick the one where you hit your target pace with the least shoulder fatigue. If in doubt on race day, leave it on 6.
Pacing: target splits and stroke rate
The classic station-1 error is racing it. You feel fresh, the crowd is loud, and the machine rewards effort instantly — so almost everyone skis the first 300 m like a time trial and spends the sled push recovering. Instead, ski the whole 1,000 m at roughly 5–10 seconds slower than your fresh best, building slightly in the final 200 m so you leave ready to run, not wrecked.
| Level | Typical SkiErg split (1,000 m) |
|---|---|
| Elite | 3:30–3:50 |
| Competitive | 3:47–4:08 |
| Age-group | 4:03–4:33 |
| First-timer | 4:26–5:05 |
Ranges computed from large samples of real HYROX results with recorded splits.
Stroke rate: around 30–38 strokes per minute suits most athletes — taller, longer-armed skiers toward the bottom of that range, shorter athletes toward the top. Spiking the rate raises your heart rate faster than it raises your pace; long, powerful strokes at a controlled rate are the efficient way down the metre counter.
How to train the SkiErg
Two short SkiErg touches a week, inside the structure of our weekly workout plan, is plenty for most racers:
| Session | Workout | Purpose |
|---|---|---|
| Intervals | 5 × 500 m at goal race pace, 90 sec rest | Build pace while rehearsing even splitting |
| Technique | 1,000 m capped at 28 strokes/min | Force distance per stroke from the hinge, not turnover |
| Compromised | 1,000 m SkiErg straight into a 1 km run at race pace | Practise the real transition into run 2 and the sled |
The SkiErg inside your race plan
Zoom out and the SkiErg is one third of an opening block that decides how the sled stations feel: run 1, ski, run 2, then the push and pull back to back. The mistake is managing each piece separately. The racers who handle the sled best treat the first twenty minutes as a single controlled effort — run 1 at a pace that feels almost too easy, the ski at the disciplined split above, and run 2 as a genuine recovery jog rather than a place to claw back seconds.
That framing also fixes your warm-up. In the start pen you can't touch a SkiErg, but you can rehearse the hinge: a few sets of band pull-downs to the hips or cable hinges in the warm-up area wake up the exact pattern — reach tall, hips back, arms long — so your first ten strokes are already grooved instead of exploratory. And plan the exit before you start: know which side your lane exits from, so that when the judge confirms your 1,000 m you're moving toward run 2 in two steps, not spinning around looking for the way out. Small things — but station 1 is where small things are still cheap.
Common SkiErg mistakes
- Treating station 1 as a time trial — the most common pacing error in HYROX. Fresh legs lie; the sled tells the truth.
- Pulling with the arms and shoulders — pre-fatigues the exact muscles the sled pull and farmers carry depend on.
- Cranking the damper to 10 — it feels powerful and skis slowly, at maximum arm cost.
- Standing bolt upright — removes the hip hinge and turns the stroke into an arms-only movement.
- Short finishes — hands stopping at the thighs leak distance on every single stroke.
- Stepping off early — always wait for the judge's confirmation at 1,000 m.
The SkiErg barely uses your legs — which is precisely why it's dangerous. It spends a currency (your arms and shoulders) that three later stations also need, and it spends it while you still feel rich.
Station 1 of eight — see the full course in our guide to all the HYROX stations.
Frequently asked questions
What damper setting should I use for the HYROX SkiErg?
The SkiErg is preset to damper 6 and you may change it. Most athletes ski best between 5 and 7: higher settings feel powerful but load the arms and shoulders you need for the sled pull and farmers carry, while a mid-range damper lets the hip hinge do the work.
What is a good 1,000 m SkiErg time for HYROX?
From real HYROX results data, typical station-1 splits are roughly 3:30–3:50 for elite athletes, 4:03–4:33 for age-group racers and 4:26–5:05 for first-timers. Remember the goal is not your fastest possible 1,000 m — it is the fastest one that leaves your legs ready for the sled push.
What are the feet rules on the HYROX SkiErg?
Both feet must stay on the SkiErg base plate — your heels may hang over the edge but cannot touch the floor. A dynamic or jumping technique where your feet briefly leave the plate is allowed. At 1,000 m, keep both feet on the plate, raise one arm and wait for the judge to confirm before stepping off.
How do I train for the SkiErg without a SkiErg?
Cable pulldowns with a hinge pattern, band pull-aparts to the hips and kettlebell swings build similar muscles, and any rowing machine work transfers aerobic capacity. But the stroke timing is specific — get on a real SkiErg for at least a few sessions before race day if you possibly can.
How hard should I go on the SkiErg in a HYROX race?
Hold roughly 5–10 seconds slower than your fresh 1,000 m pace. Station 1 is where adrenaline makes everyone overreach, and time grabbed here is repaid with interest on the sled push that follows. Leave the machine breathing hard but in control.
Want more like this? Browse the Stations category.
Fitness disclaimer: Training involves physical risk. The content on this page is educational and is not medical advice. Consult a qualified professional before starting a new training program, especially if you have any health condition or injury.


